Fiat Punto GT Turbo engine wiring harness restoration electrical connectors and terminals kit, this pack is usually purchased by those who want to restore the control unit-engine wiring as they have noticed that the wiring is now ruined and want to restore it to new condition.

The kit includes connectors, rubbers to allow insulation from water and the entire list of connectors below:

• 6 two-way female connectors with terminals, for injectors and air and water temperature sensors
• 3 3-way female connectors with terminals for potentiometer, idle motor and rpm sensor
• 1 7-way female connector for power module

We always add a few more terminals in case of a crimping mistake, so as not to have precise terminals and in case of a bad crimping, we have no terminals.

This kit MISSES THE 6-way connector for the air flow meter and the 3-way extended female connector for the phase sensor which you can purchase separately in the accessories item.

It is possible to choose to add from the menu also the wire protection rubbers on the connector. Total of 10 rubbers of different sizes based on the width of the connector at a small higher cost.