Three-position switch

With this relay you can activate and keep activated a load up to 30amp and then turn it off by removing the impulse to drive any accessory up to 30 amps

Inertial safety switch that disconnects the contact in the event of a collision. 2 connection wires.

Ignition switch with double key

Normally open red button with fixing ring and two screwed poles.

With this you can simply relay via a pulse with control switch and hold a load up 100amp activated and then always turn it off with the usual impulse.

Pull switch, very convenient to turn anything on or off.

With this relay you can invert the 12 volt commands so as to obtain opposite results to the command such as on the exhaust valves

Military type switch with safety protection, blue color.
Suitable for any use, notable aesthetic impact.

This control unit allows to set a threshold from 0-5 volts that when exceeding a selected voltage activates a relay such as the prot oxide relay or any other activation

Pull switch, very convenient to activate something.

Military type switch with safety protection, chrome color.
Suitable for any use, notable aesthetic impact.

Activate mapping 1 or mapping 2 directly with a simple push of a button on the remote control. An easy way to avoid having to install visible buttons only for all Unichip ECUs, any model and many other ECUs.

Turn any electrical component on or off with a 12 volt power supply with the push of a button on your remote. Typically used to open or close exhaust flaps or turn something on/off.

Button with extensible spiral wire for normally open activation which can be fixed on the steering wheel for activations of any kind

24v relay which, through a very fast impulse with negative or positive command, can activate and keep activated a load of up to 20 amps and then always turn it off with the usual impulse of a few milliseconds, and so on. To be used in direct current DC.

With this relay you can simply by using a very fast pulse with negative or positive command, activate and hold a load up to 20amp and then always turn it off with the usual pulse of a few milliseconds, and so on. 814