Reinforced head gasket with separate rings for Renault K7M 1600 8V Megane or Clio Turbo or also aspirated

Single mass steel flywheel kit reinforced clutch Alfa Romeo 159 1750 Tbi 200hp with special ferodo disc with copper braids in the mix (also visible in the photos) and special reinforced pressure plate complete with dedicated reinforced screws. Choose the two versions based on the torque to be supported and consequently the force to be applied to the clutch pedal will also change a little...

Head gasket with separate rings from SUPPORT for BMW M20B25 6 cylinder engine

Mitsubishi Pajero 2800 V20 Turbodiesel sandwich support for installing external ergal oil cooler with 2 holes for pressure - temperature sensors.

Wireless control unit for opening the exhaust on the Alfa Romeo Giulia Quadrifoglio Verde 2.9L biturbo engine, allowing you to bypass the valve management on the original exhaust by opening and closing it as desired from inside the passenger compartment using a wireless remote control.

Specific support Toyota Land Cruiser LJ80 4200 Turbo Diesel diesel 6 cylinder 160 -165 hp which allows the installation of the external oil radiator, with holes to possibly place the oil pressure and temperature sensors.

Corasse turbo repair service already balanced.

Renault Clio 3.000 V6 sports exhaust manifolds made of stainless steel as a replacement for the original ones

Toyota Celica GT4 Four Turbo high flow fuel pump, suitable for maintaining power up to 400hp complete with filter and electrical wiring to be installed inside the original basket. Fuel pump that can be installed on all Toyota Celica GT4 Four Turbo ST 165- ST185 ST205 models from 1988 to 1999

Tachometer module for use when your existing tachometer cannot be connected to any sensor on your petrol or diesel vehicle. It installs quickly and allows you to immediately send a signal to your tachometer by attaching our module.

Kit of clamps and flanges rings for V-band couplings for insertion of 76mm external muffler pipe.

Stainless steel ring flange that must be welded onto the wastegate exhaust outlet in order to create the muffler that expels the exhaust gases from the 44mm Tial MVR external wastegate.