Remember! Find it on ProtoXide only!

Reinforced Single-Mass Flywheel Kit Alfa Romeo Giulietta 2000 140 -150hp - 170hp JTDM

Reinforced Single-Mass Flywheel Kit Alfa Romeo Giulietta 2000 140 -150hp - 170hp JTDM

€1,399.60

Tax included

Usually shipped within 24 hours

Single-mass flywheel and reinforced clutch kit Alfa Romeo Giulietta 2000 16v 140-150-170 hp installable on all versions with 2000 JTDM engine with manual transmission, including the following engine codes: 940A4000 940A5000 940B5000 940C3000. The kit includes a modified thrust bearing and specific high traction flywheel bolts.

Version :

Quantity :

Write your review

SECURE ENCRYPTED PAYMENTS
ORDER ALWAYS TRACKABLE
SAFE AND PROTECT PROTOXIDE PACKAGING

Description
Product Details

Flywheel kit with steel single-mass and reinforced clutch Alfa Romeo Giulietta 2000 JTDM 140-150-170hp capable of handling from 50KGM up to 59kgm of torque depending on the model purchased. Installable on any version with this engine type including these engine codes: 940A4000 940A5000 940B5000 940C3000.
Kit with special steel single-mass flywheel designed to accommodate a specific disc created for turbo diesel with dual shock absorber, also compatible with other vehicles with the same engine type including LANCIA DELTA III FIAT BRAVO II 2.000
This kit includes: steel flywheel, super reinforced pressure plate, and clutch with reverse-loaded damper springs and new screws specific for this application.
The problems of dual-mass flywheel breakage are known when increasing horsepower (even just through ECU reprogramming) or the clutch slipping even just after ECU remapping or adding a modified turbocharger. Many of you contact us because you have already changed several reinforced clutches and continue to burn them, but for us, there is nothing unusual for this engine, as for many others, our kit is the only one to maintain up to 59kgm of torque.
Steel flywheel complete with starter gear ring, complete with special ferodo disc with copper inside the mixture, but it is not a disc with copper plates ProtoXide.
High traction specific American bolts for attachment to the crankshaft, included in the package, specific for this application.
Unique kit entirely designed and developed EXCLUSIVELY in ProtoXide.
This kit allows eliminating the issues present in acceleration at low revs, especially in higher gears, caused by clutch slipping with the flywheel, thanks to a reinforced pressure plate and a ferodo disc.
INCLUDED IN THE KIT is also the specific thrust bearing with integrated bushing already installed by us provided.
ProtoXide assumes no responsibility due to an unsuitable choice of application for your vehicle, even though it is always possible to replace it with the correct type at no additional cost, and in any case, with each order received, a technician will contact you to verify with you the correct model for your application.
Competition complete kit exempt from any type of warranty
ProtoXide assumes no responsibility for any vibrations that may occur during the normal operation of the engine, due to the removal of the original dual-mass flywheel, as our products are intended only for competition vehicles where the only priority is greater performance at the expense of everything else, noise, comfort, and durability (especially when an application involves the use of copper material).