With this module improperly called digital relay, you can simply activate, keep activated or pulse a load up to 100 amps with a pulse from 3 to 28 volts.
With newly built 12 volt relays you can simply use a very fast impulse with a negative or positive command to activate and keep a load of up to 20amp activated and then always turn it off with the usual impulse of a few milliseconds, and so on. To be used in direct current DC.
It is found in multiple uses from control units for competition on cars or on industrial vehicles such as excavators 01170716 and agricultural vehicles and nautical applications.
This control unit allows to set a threshold from 0-5 volts that when exceeding a selected voltage activates a relay such as the prot oxide relay or any other activation
Activate mapping 1 or mapping 2 directly with a simple push of a button on the remote control. An easy way to avoid having to install visible buttons only for all Unichip ECUs, any model and many other ECUs.
This complete kit allows to by-pass the management of the valves on the original exhaust by activating and deactivating it at will using the engine depression that must already be present on the car.
With this relay you can manage stable controls and avoid return currents from magnets or electric motors so as not to spoil the control driver itself or the control unit.
Enable or disable up to 4 relays from a 12 volt supply with the simple press of one of the 4 buttons on your remote. Normally used to open or close exhaust throttles, change maps, or toggle something on/off, screw terminals