Activator remote control

With this module improperly called digital relay, you can simply activate, keep activated or pulse a load up to 100 amps with a pulse from 3 to 28 volts.

This control unit allows to set a threshold from 0-5 volts that when exceeding a selected voltage activates a relay such as the prot oxide relay or any other activation

Blue illuminated engine start button with dedicated relay box

With this relay you can activate and keep activated a load up to 30amp and then turn it off by removing the impulse to drive any accessory up to 30 amps

Normally open red button with fixing ring and two screwed poles.

With this you can simply relay via a pulse with control switch and hold a load up 100amp activated and then always turn it off with the usual impulse.

Turn anything on or off with the push of a button from your remote.

Button with extensible spiral wire for normally open activation which can be fixed on the steering wheel for activations of any kind

Battery cut-off switch with deactivatable key

Military type switch with safety protection, blue color.
Suitable for any use, notable aesthetic impact.

Switch with red LED integrated.

Enable or disable up to 4 relays from a 12 volt supply with the simple press of one of the 4 buttons on your remote. Normally used to open or close exhaust throttles, change maps, or toggle something on/off, screw terminals

With this relay you can invert the 12 volt commands so as to obtain opposite results to the command such as on the exhaust valves

24v relay which, through a very fast impulse with negative or positive command, can activate and keep activated a load of up to 20 amps and then always turn it off with the usual impulse of a few milliseconds, and so on. To be used in direct current DC.