Wastegate Ferrari 208 GTS and GTB Turbo VERSION WITHOUT INTERCOOLER. external type valve for turbocharger on original exhaust manifold. It is installed in place of the original Ferrari wastegate which is now in a non-restorable condition and even with the replacement of the membrane, the problems will only be postponed. This wastegate of ours has the usual hole diameter but carries a...

Reinforced head gasket Autobianchi A112 Abarth separate rings with "Cooper" type support.

Toyota Hilux 2446 engine code 2L Turbo Diesel oil cooler sandwich support which allows the installation of the external oil cooler, with 2 holes to possibly install the oil pressure temperature sensors.

Double hose clamp with 16mm aluminum double clamp separator

Reinforced crankshaft gear pulley Fiat 500 Abarth Grande Punto 1400 16v turbo compatible with many other vehicles such as Panda 100 HP Alfa Romeo Mito always with 1400 16v engines also aspirated, in special hardened and hardened steel. Original timing gear with original Fiat code 55203781 46520164 405478

Reinforced trimetallic manifold gasket for Alfa Romeo, Fiat, Lancia, Opel 1300 MultiJet engines such as 500, Punto, Panda, Mito 500 L, Idea Linea etc..

External wastegate Porsche 944 for specific installation complete with exhaust pipe that goes back into the muffler. Compared to other solutions on the market, we use a wastegate of the same size as the original and with greater lift, and not a solution with a reduced hole to cost less at the expense of performance. Furthermore, we provide a complete kit with specific piping that is mounted...

Three-way solenoid valve to be used for managing pneumatic valves on the exhaust of your car or motorbike, pop off valves for turbo diesel, etc. Solenoid complete with filter as shown in the figure, which can also be removed.

Exhaust valve for the AUDI RS3 TTRS 2500 to be used in place of the original valve. It is necessary to screw on the original motor with the three 8mm bolts and a 13mm wrench, using our dedicated spring to secure the motor to the valve's crescent.

Injector adapters that allow you to remove the injector nose so you can install them without making any changes to intake manifolds that do not have the injector nose provision on the intake manifold and cylinder head. Adapter +12mm

Spark plug cables Renault Clio RS 2000 16v. 4 cables with very high conductivity only 100 ohm per meter!

Single-mass steel flywheel kit Reinforced clutch JEEP RENEGADE 1600 120hp TurboDiesel engine code 55260384 CRD with lightened steel flywheel machined from solid with reinforced clutch ProtoXide with brake disc with flexible coupling springs, unique creation ProtoXide exclusively, the only ones to make it.