- Remember! Find it on ProtoXide only!
World's Fastest Online Shop !
World's Fastest Online Shop !
Single Mass Flywheel Kit Reinforced Clutch Alfa Romeo Giulietta 1750 tbi 235hp
€1,400.00
Tax included
Single-mass steel flywheel kit reinforced clutch Alfa Romeo Giulietta 1750 Tbi with special ferodo disc and special reinforced pressure plate complete with dedicated screws. Choose the two versions based on the torque to be supported and consequently the force to be applied to the clutch pedal will also change a little depending on the version purchased.
SECURE ENCRYPTED PAYMENTS
ORDER ALWAYS TRACKABLE
SAFE AND PROTECT PROTOXIDE PACKAGING
- Single-mass flywheel and reinforced clutch kit for Alfa Romeo Giulietta 1750 TBi complete with starter motor crown.
- This kit is supplied exclusively by ProtoXide and is composed of a steel flywheel, a super reinforced pressure plate and a clutch with reverse-loaded shock absorber springs and a series of reinforced screws specific for this application which is capable of withstanding 50KGM of torque in the two types of versions or up to 59KGM of torque in the second version!
- UNICO ProtoXide special ferodo disc with copper braids in the mix that can also be seen with the naked eye and not with the annoying copper plates at the start. On request with an additional cost we can replace the special ferodo disc with a disc with copper plates.
- There are known problems with the dual mass flywheel breaking when increasing the standard horsepower (even just by reprogramming the ECU) or the clutch slipping even just after remapping the ECU or adding a modified turbocharger. Many of you contact us because they have already changed several reinforced clutches and continue to burn them, but for us there is nothing strange for this engine as for many others our kit is the only one to maintain up to 59kgm of torque.
- Including high tensile bolts for fixing to the crankshaft, included in the package, specific for this application.
- This kit eliminates problems present in acceleration even at low revs, especially in higher gears, caused by the failure of the "original dual mass flywheel" thus eliminating clutch or flywheel slippage, thanks to a reinforced clutch pressure plate and a special ferodo disc.
- Also INCLUDED in the kit is the specific thrust bearing with integrated bushing modification and already installed for use with this reinforced clutch kit.
- ProtoXide assumes no responsibility due to a non-compliant choice of application for your vehicle, even if it is always possible to replace it with the correct type without further costs, and in any case for each order received, one of our technicians will contact you to verify together with you the correct model for your application.
- Protoxide assumes no responsibility for any vibrations that may be created during normal engine operation, due to the removal of the original dual-mass flywheel, as our products are only suitable for racing vehicles where the only prerogative is greater performance to the detriment of everything else, noise, comfort and durability (especially when an application involves the use of copper material).
Specific References
Single-mass steel flywheel kit reinforced clutch Alfa Romeo Giulietta 1750 Tbi with special ferodo disc and special reinforced pressure plate complete with dedicated screws. Choose the two versions based on the torque to be supported and consequently the force to be applied to the clutch pedal will also change a little depending on the version purchased.
Single Mass Flywheel Kit Reinforced Clutch Alfa Romeo Giulietta 1750 tbi 235hp
€1,400.00
Tax included