To give you the best possible experience, this site uses cookies. Using your site means your agree to our use of cookies. We have published a new cookies policy, which you should need to find out more about the cookies we use. View Cookies Policy.
Exhaust manifold flange Mitsubishi Lancer Evo 7 8 9 2000 Exhaust manifold flanges
  • Remember! Find it on ProtoXide only!
  • New
  • Remember! Find it on ProtoXide only!
  • New
  • Remember! Find it on ProtoXide only!

    Single-mass flywheel kit for the Fiat Bravo reinforced-Stilo 115-120 hp

    €1,467.00
    Tax included
    Usually ships in 24 hours

    Kit with flywheel mass in special steel mono-made to accommodate a specific disk with springs thrust complete with crown billet.

    Quantity :
    Write your review

    EU3234363840424446USXX5XSSMLXLXXLXXLArm Length6161,56262,56363,56464,5Bust Circumference8084889296101106111Waist Girth6165697377828792Hip Circumference87919599103108113118

    • SECURE ENCRYPTED PAYMENTSSECURE ENCRYPTED PAYMENTS
    • ORDER ALWAYS TRACKABLEORDER ALWAYS TRACKABLE
    • SAFE AND PROTECT PROTOXIDE PACKAGINGSAFE AND PROTECT PROTOXIDE PACKAGING

    There are known problems of breakage of the dual mass flywheel when increasing the number of horses (even if only by reprogramming the control unit).

    • steel flywheel complete with crown for the starter
    • disc brake pad (not copper) PROTOXIDE with battery reinforced with 3 dampers specifically designed to reduce vibration and "loaded "to be installed upside down.
    • crankshaft bolts specific for this application including
    • Original reinforced pressure plate
    • The weight of the whole assembly is about 16kg.
    • This kit eliminates the problems present in acceleration even at low engine speeds, especially in the higher gears, caused by the failure of the "dual-mass flywheel original" thus eliminating slipping clutch or flywheel, pressure plate reinforced for about one and a disc brake padPROTOXIDE only unobtainable 
    • E 'need to use the original thrust bearing to be purchased at the dealer because they do not understand.
    • PROTOXIDE assumes no liability due to a non-compliant application choice for your car, although you can always replace it with the correct type, and in each case, for each order received, it will be one of our technicians contact you to verify together to you the correct model for your application.
    • Protoxide assumes no responsibility for any vibrations that can occur during normal operation of the engine, due to the removal of the original dual-mass flywheel, as our products are suitable only for racing vehicles where the only prerogative are the major performance at the expense of everything else,Noise, comfort and durability(Especially when an application involves the use of copper material).
    ProtoXide

    Specific References