Single-mass steel flywheel kit with reinforced copper twin-disc clutch for Fiat 500 Punto Panda 1300 JTD MJET 75-95hp

Single-mass steel flywheel kit with reinforced copper twin-disc clutch for Fiat 500 Punto Panda 1300 JTD MJET 75-95hp

kr17,346.58

Tax included

Last items in stock

Lightweight steel flywheel complete with reinforced twin-plate clutch kit with copper clutch discs for Fiat 500 Punto Panda Turbo 1300 JTD 75-90-95hp with double crown for starter motor and also the crown already inserted and timed for the rpm sensor. Only for the version with Fiat 22-spline hydraulic pump bearing.

Accessories :

Quantity :

Write your review

SECURE ENCRYPTED PAYMENTS
ORDER ALWAYS TRACKABLE
SAFE AND PROTECT PROTOXIDE PACKAGING

Description
Product Details

Reinforced copper twin-plate clutch kit with steel flywheel that can be installed on all Fiat Grande Punto, Fiat 500 Turbo 1300 JTD 75-90-95hp engines and similar engines. Specify the exact model where it will be installed when purchasing. IT MUST HAVE A 20-GROOVE CLUTCH DISC. IF YOUR GEARBOX HAS A 22-GROOVE HUB, IT IS NOT POSSIBLE TO MAKE IT. This clutch hub is usually used on 6-SPEED gearboxes with a hydraulic bearing. IF THE BEARING IS MECHANICAL, IT IS NECESSARY TO PURCHASE ANOTHER KIT.
Reinforced double copper disc clutch kit with reinforced light alloy Ergal pressure plate with copper plates, complete and lightened by almost 1.5 kg compared to the original assembly.
Complete with starter motor crown and tone wheel in case the original model was equipped with it as standard.
This is the complete solution to all clutch slippage in these super-tuned 1300 Mjet engines, which everyone continues to replace with single-disc clutches that promptly slip or break after a short time.
ProtoXide assumes no responsibility for an incorrect application choice for your vehicle, even if it is always possible to replace it with the correct type at no additional cost, and in any case, for each order received, one of our technicians will contact you to verify with you the correct model for your application.
Protoxide assumes no responsibility for any vibrations that may be created during normal engine operation due to the removal of the original dual-mass flywheel, as our products are intended only for racing vehicles where the only prerogative is maximum performance at the expense of everything else, noise, comfort and durability (especially when an application involves the use of copper material).