- Remember! Find it on ProtoXide only!
World's Fastest Online Shop !
World's Fastest Online Shop !
Steel single mass flywheel kit with reinforced clutch Alfa 159 - Croma 1900 JTDM 16v 150 Hp COPPER
€1,499.00
Tax included
Single mass steel flywheel kit with specific clutch and copper disc for Alfa 159 - Fiat Croma 1900 16v JTDM 150 hp and 200 hp engine code 939A2000 and 939A3000
SECURE ENCRYPTED PAYMENTS
ORDER ALWAYS TRACKABLE
SAFE AND PROTECT PROTOXIDE PACKAGING
- Steel single-mass flywheel kit with specific COPPER clutch for Alfa 159 - Croma 1900 16v JTDM 150 hp and 200 hp There are known problems of breakage of the dual-mass flywheel when the standard horsepower is increased (even just by reprogramming the control unit) and slipping of the clutch after remapping the control unit or adding a modified larger turbocharger.
- Kit with special single-mass steel flywheel made to accommodate a specific 20 disc created for Turbodiesell with large springs to dampen vibrations as much as possible.
- This kit is supplied with: steel flywheel, super reinforced pressure plate and clutch with 240mm reverse loaded coupling springs and a set of new screws specific for this application.
- The crown for the starter motor has already been inserted by us on our flywheel
- Steel flywheel complete with crown for the starter motor, ProtoXide ferodo disc (not copper) with reinforced battery with 3 shock absorbers specifically designed to reduce transmitted vibrations and "loaded" in reverse.
- There are known problems with the dual mass flywheel breaking when the standard horsepower is increased (even just by reprogramming the control unit) or the clutch slipping after remapping the control unit or adding a modified turbocharger. Kit with special single-mass steel flywheel made to accommodate a specific disc created for turbodiesels with double shock absorbers
- This kit is supplied with: steel flywheel, super reinforced SASCH PERFORMANCES 59KGM pressure plate and clutch with reverse-loaded coupling springs and a set of new screws specific for this application.
- The crown for the starter motor is already inserted on our single-mass flywheel.
- The specific flywheel bolts for this application are already included in our package. The weight of the whole assembly is approximately 16kg.
- This kit allows you to eliminate the problems present in acceleration even at low speeds, especially in the higher gears, caused by the failure of the "original dual mass flywheel", thus eliminating clutch or flywheel slipping, thanks to a reinforced pressure plate and a unique and hard to find ProtoXide lining disc
- It is necessary to use the original thrust bearing which must be purchased separately as it is not included.
- ProtoXide does not assume any responsibility due to a non-compliant choice of application for your car, even if it is always possible to replace it with the correct type without further costs, and in any case for each order received, one of our technicians will contact you to check with you the correct model for your application.
- Protoxide assumes no responsibility for any vibrations that may be created during the normal operation of the engine, due to the removal of the original dual-mass flywheel, as our products are only suitable for racing vehicles where the only prerogative is greater performance to the detriment of everything else, noise, comfort and durability (especially when an application involves the use of copper material).
Specific References
Single mass steel flywheel kit with specific clutch and copper disc for Alfa 159 - Fiat Croma 1900 16v JTDM 150 hp and 200 hp engine code 939A2000 and 939A3000
Steel single mass flywheel kit with reinforced clutch Alfa 159 - Croma 1900 JTDM 16v 150 Hp COPPER
€1,499.00
Tax included