YELLOW military type baby go switch

Button with extensible spiral wire for normally open activation which can be fixed on the steering wheel for activations of any kind

Circuit built and programmed according to your needs up to 2 relays.

Turn any electrical component on or off with a 12 volt power supply with the push of a button on your remote. Typically used to open or close exhaust flaps or turn something on/off.

With this relay you can simply by using a very fast pulse with negative or positive command, activate and hold a load up to 20amp and then always turn it off with the usual pulse of a few milliseconds, and so on. 814

Battery cut-off switch with deactivatable key

Waterproof protection suitable for scooters, motorcycles, boats.

With this module improperly called digital relay, you can simply activate, keep activated or pulse a load up to 100 amps with a pulse from 3 to 28 volts.

Waterproof protection suitable for scooters, motorcycles, boats.

With this relay you can activate and keep activated a load up to 30amp and then turn it off by removing the impulse to drive any accessory up to 30 amps

Three-position switch.

Normally open red button with fixing ring and two screwed poles.

Blue illuminated engine start button with dedicated relay box

Ignition switch with double key

This control unit allows to set a threshold from 0-5 volts that when exceeding a selected voltage activates a relay such as the prot oxide relay or any other activation

Pull switch, very convenient to turn anything on or off.

Activate mapping 1 or mapping 2 directly with a simple push of a button on the remote control. An easy way to avoid having to install visible buttons only for all Unichip ECUs, any model and many other ECUs.