ProtoXide pressure sensor that can be installed on Lancia Delta 2000 8-16v 4WD instead of the original Marelli 02/02 Aps sensor, Lancia code 77581420 allows you to measure the turbo pressure up to a maximum of
Increased pressure sensor up to 3.5 Bar absolute and can be used on any control unit that accepts a 0-5 volt input signal, especially on Turbodiesel engines but also on petrol turbos when you want to avoid the engine failure warning light and at the same time increase the turbo pressure .
Linear pressure sensor up to 10 bar with 0-5 volt output that can be used to measure the pressure of gasoline, oil, air and other liquids. 5 volt power supply
Linear pressure sensor up to 100 bar with 0-5 volt signal output can be used to measure the pressure of petrol, oils, air, nitrous oxide and other liquids. Power supply from 12 to 30 volts.
Adjustable pressure switch from 0.1 to 2 bar, with normally open contacts with rear adjustment screw. It can be used for example to activate a positive to pulse the additional injectors when a certain pressure is reached, or to activate something when a certain pressure is reached and deactivate it when it goes below. Useful for also driving additional injectors
Increased pressure sensor up to 4 Bar absolute and can be used on any control unit that accepts a 0-5 volt input signal, especially on Turbodiesel engines but also on petrol turbos when you want to avoid the engine failure warning light and at the same time increase the turbo pressure .
Pressure sensor 05-01 installed on Lancia Delta 2.000 Ford Escort - Sierra Cosworth, allows to measure the turbo pressure up to a maximum of 2 bar and depression -1 bar, absolute pressure 3 bar. Usually this original sensor is gray while ours will be black.
Turbo pressure sensor with working range up to 2 bar turbo and 3 bar absolute for 1800 -2000 20v 16v TFSI TSI engines and in any case all cars of the Volkswagen Audi Skoda group 4-wire connector.