Single-mass flywheel kit Passat 1900 TDI Audi A4 130 hp AVF with reinforced clutch

Steel flywheel complete with single plate clutch in copper

flywheel kit in lightened steel with included reinforced clutch kit with pull type and copper disc.

Kit flying ultralight aluminum with reinforced clutch installed on SJ 1000 1300 8v and 16v.

Volkswagen Scirocco 2000 140hp Turbodiesel racing single-mass flywheel kit complete with reinforced Sasch Performance pressure plate, different version with more load than the reinforced Sasch performance for this model and ferodo clutch disc with copper braids in the ProtoXide compound.

Kit with steel flywheel Renault Clio 3 RS3 200 hp - 203hp R3 F4r830 in steel with reinforced single-disc copper clutch with Ergal bell for SADEV GEARBOX (not suitable for other applications with original gearbox), which allows you to have a super lightened clutch assembly all machined from solid, with 60-2 tone wheel for reading with sensor for original control unit and racing control units and relative crown for starter motor included.

Single-mass flywheel kit complete with reinforced pressure plate and clutch lining disc.

Steel single-mass flywheel kit with clutch specific to Alfa 159 2000 - Fiat Croma 1900 16v JTDM 150 hp and 200 hp engine code 939B3000 125 KW with F40 gearbox transmission. This is a model used exclusively for this specific application which as standard uses an original dual mass flywheel 55214811 with F40 transmission with a wear recovery pressure plate, while our application allows you to remove the wear recovery system using a traditional system but which allows to maintain a torque of 59kgm!

Lightweight single-mass steel flywheel complete with reinforced single-disc clutch with reinforced push-type pressure plate for all Alfa Giulia 2200 turbodiesel engines with manual gearbox, super-reinforced pressure plate with no wear recovery and clutch disc with reinforced springs dedicated for this application!

Kit Steel flywheel + copper clutch 4 plates + reinforced pressure plate Fiat Motori Fire increased diameter. Incorrect photo.

Fiat Panda 100 HP Flywheel Kit with reinforced clutch with lightened steel flywheel with reinforced copper clutch with bell machined from solid. It can be used in all applications with Fire engines that use clutches up to a maximum of 200mm.

Flywheel kit in lightened steel with copper-reinforced clutch with pressure plate bell machined from solid, with Renault tone wheel for reading with sensor for the original control unit and competition control units.

Flywheel and clutch kit reinforced with single-mass flywheel in lightened steel, specific for Fiat Alfa Lancia cars such as Giulietta 1.6 Mjet, 1600 MJET 105hp ALFA ROMEO Giulietta, Fiat BRAVO 2 etc. 88kw