This kit is equipped with a single-mass flywheel in steel, a super-reinforced pressure plate and a clutch with a ferrule disc (not in copper).
Engine code cff - cffb
Couple max. 59kgm
It is necessary to use the original thrust bearing to be purchased in the dealership as it is not included.
ProtoXide assumes no responsibility due to an improper choice of the application for your car, even if you can always replace it with the correct type without further costs, and in any case with each order received, one of our technicians will contact you to check with you the correct model for your application.
Protoxide assumes no responsibility for any vibrations that may occur during normal engine operation, due to the removal of the original bi-mass flywheel, as our products are only indicated for competition vehicles where the only prerogatives are the greatest performances to the detriment of all the rest, noise, comfort and durability (especially when an application involves the use of copper material).
Total weight kg.
It is installed on the whole seat audi and vw group with 2 and 4-wheel drive.
Kit with flywheel in special single-mass steel made to accommodate a specific disc with robust thrust springs and clutch with 5 copper plates. Sometimes installed also on some Fiat 188B2000 versions. Consumed on engines prepared at the limit of 300 hp.
Kit with flywheel in super lightened steel with reinforced clutch in copper with bell made from solid, with 60-2 phonic wheel for reading with sensor for original control unit and competition control units.
Kit with flywheel in steel with reinforced clutch in copper cbidisco on bell, machined from billet, with phonic wheel 60-2 for reading with sensor and original control unit and modification for pump - clutch bearing.