To give you the best possible experience, this site uses cookies. Using your site means your agree to our use of cookies. We have published a new cookies policy, which you should need to find out more about the cookies we use. View Cookies Policy.
copy of Spark plug wires Fiat Punto Fire engine 1100 - 1200 8V high conductivity red distributor Car-specific spark plug cables
  • Remember! Find it on ProtoXide only!
  • New
copy of Spark plug wires Fiat Punto Fire engine 1100 - 1200 8V high conductivity red distributor
€199.00
Exhaust manifold flange Mitsubishi Lancer Evo 7 8 9 2000 Exhaust manifold flanges
  • Remember! Find it on ProtoXide only!
  • New
Exhaust manifold flange Mitsubishi Lancer Evo 7 8 9 2000
€64.00
  • Remember! Find it on ProtoXide only!
  • New
copy of Lambda probe connection bushing cut at an angle
€14.42
  • New
copy of Reinforced head gasket Renault 5 GT Turbo 1400 separate rings from support
€239.50
Valve for opening and closing the exhaust at VACUUM based on the turbo pressure Exhaust Valve muffler
  • On sale!
  • New
Valve for opening and closing the exhaust at VACUUM based on the turbo pressure
€247.00
  • Remember! Find it on ProtoXide only!

    Single mass steel flywheel kit with reinforced clutch Opel Astra TD

    €1,077.17
    Tax included

    Kit with single-mass steel flywheel, for Opel Astra, made to accommodate a specific disc with thrust springs and complete with crown.

    Quantity :
    Wishlist
    No Product available
    Write your review

    EU3234363840424446USXX5XSSMLXLXXLXXLArm Length6161,56262,56363,56464,5Bust Circumference8084889296101106111Waist Girth6165697377828792Hip Circumference87919599103108113118

    • SECURE ENCRYPTED PAYMENTSSECURE ENCRYPTED PAYMENTS
    • ORDER ALWAYS TRACKABLEORDER ALWAYS TRACKABLE
    • SAFE AND PROTECT PROTOXIDE PACKAGINGSAFE AND PROTECT PROTOXIDE PACKAGING
    • Single mass steel flywheel kit with reinforced clutch Opel Astra T urbo diesel
    • There are known problems with the dual mass flywheel breaking when the standard horsepower is increased (even just by reprogramming the control unit).
    • Steel flywheel complete with crown for the starter motor
    • ProtoXide ferodo (not copper) disc with reinforced battery with 3 shock absorbers specifically designed to reduce vibrations and "loaded" in reverse.
    • Crankshaft bolts specific to this application included
    • original reinforced pressure plate
    • The weight of the whole assembly is approximately 16kg.
    • Can be installed on many models
    • This kit allows you to eliminate the problems present in acceleration even at low speeds, especially in the higher gears, caused by the failure of the "original dual mass flywheel", thus eliminating clutch or flywheel slipping, thanks to a reinforced pressure plate and a unique and hard to find ProtoXide lining disc
    • It is necessary to use the original thrust bearing to be purchased at the dealership as it is not included.
    • ProtoXide does not assume any responsibility due to a non-compliant choice of application for your car, even if it is always possible to replace it with the correct type without further costs, and in any case for each order received, one of our technicians will contact you to check with you the correct model for your application.
    • Protoxide assumes no responsibility for any vibrations that may be created during the normal operation of the engine, due to the removal of the original dual-mass flywheel, as our products are only suitable for racing vehicles where the only prerogative is greater performance to the detriment of everything else, noise, comfort and durability (especially when an application involves the use of copper material).
    ProtoXide

    Specific References