Fiat Punto 1200 16V lightweight aluminum flywheel, track diameter 190mm.
Choosing the flywheel version whether balanced or not, even if the flywheel will be very precise, since it is a CNC made flywheel like all flywheels sold without clutch application, it is full responsibility of the customer to decide and assume the type of clutch to be used in full responsibility of their project.
Balancing is usually done with a very small, non-through hole.
Weight approximately 3 kg, complete with starter motor crown already inserted.
Flywheel not approved for road use, for track use only.
Kit with single-mass steel flywheel made with reinforced clutch kit with specific cushioned lining disc for Fiat Alfa Lancia 1300 MultiJet Turbodiesel engines.
Lightweight steel flywheel Renault 5 GT 1400 Turbo replaceable equal-to-equal with the original flywheel but with lighter weight and made with greater resistance in steel and not in cast iron like the original flywheel.
Lightweight steel flywheel for Fiat Panda 100HP Fiat Idea engines and similar aspirated 1400 16v engines also usable with reinforced lining clutch or with copper plates
Aluminum flywheel suitable for single plate clutch is not balanced. Weight 15.2 kg 8.2kg against the original. Requires insertion of the crown of the series and its balancing.
Renault Clio 1800 - 2000 Williams lightened steel flywheel, replaceable like-for-like with the original flywheel but with a lighter weight and made with greater resistance in steel and not in cast iron like the original flywheel.
Light steel flywheel for Fiat Panda Punto Fiat 600 , Fiat GrandePunto 1200 and similar engines Grandepunto 1400 95 and Alfaromeo Mito 1400 16v non turbo engines that have mounted the 500 Abarth turbo engine. This application must be purchased by those who have installed a turbo engine on their vehicle that had the 1200 aspirated Fire and kept the original 1100 or 1200 gearbox.
Ultra-light single-mass steel flywheel to be replaced identically with the standard one, complete with crown for revolution sensor for Renault Clio 3000 V6 Maxi for standard clutch that can be installed on original phase 1 and phase 2 versions.
Lightweight steel flywheel Renault Clio 2 1400 - 1600 8 - 16v with rpm sensor crown as original, replaceable like-for-like with the original flywheel but with lighter weight and made with greater resistance in steel and not in cast iron like the original flywheel.
Ultra-light single-mass aluminum flywheel Renault Clio 3000 V6 phase 1 -2 to be replaced identically with the standard one, complete with crown for phase sensor and crown for idle motor.